Brake Fluid Pressure Sensor/Switch: Service and Repair

Brake Fluid Pressure Sensor Replacement

Removal Procedure

Important: The area around the electronic brake control module (EBCM) must be free from loose dirt to prevent contamination of disassembled ABS components.

1. Thoroughly clean all contaminants from around the EBCM.




2. Disconnect the brake fluid pressure sensor electrical connector (3) from the brake fluid pressure sensor (2).
3. Remove the brake fluid pressure sensor (2) from the EBCM (1).

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.




1. Install the brake fluid pressure sensor (2) to the EBCM (1).

Tighten the brake fluid pressure sensor to 17 N.m (13 lb ft).

2. Connect the brake fluid pressure sensor electrical connector (3) to the brake fluid pressure sensor (2).
3. Fill and bleed the hydraulic brake system.
4. Perform the Auto Bleed Procedure.
5. Perform the Diagnostic System Check - Vehicle. Go to Diagnostic System Check - Vehicle. Initial Inspection and Diagnostic Overview