Removal and Replacement

Throttle Body Assembly Replacement

Removal Procedure

1. Turn the ignition OFF.
2. Remove the air cleaner intake duct.






Notice: Refer to Disengaging Connectors Notice in Cautions and Notices.

3. Remove the throttle body electrical connector.




4. Unlock and reposition the wiring harness conduit.




5. Remove the throttle body bolts.
6. Remove the throttle body and gasket.

Installation Procedure

1. Carefully clean the throttle body mounting surfaces of any gasket and/or seal material.




2. Install the throttle body and NEW gasket.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the throttle body bolts.

Tighten the throttle body bolts to 10 N.m (89 lb in).




4. Install the wiring harness conduit.




5. Install the throttle body electrical connector.
6. Install the air cleaner intake duct.
7. Perform the idle learn procedure. Refer to Idle Learn. Programming and Relearning
8. Use the scan tool to clear all DTCs.