Shock Module Yoke Replacement

Shock Module Yoke Replacement (RWD)

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the shock to yoke retaining nut (1).
4. Remove the shock to yoke retaining bolt (2) by pulling up slightly on the lower control arm to remove the pressure on the bolt.





5. Remove the yoke to lower control arm bolt (1).
6. Remove the yoke (2) from the vehicle.

Installation Procedure





1. Position the yoke (2) to the shock and control arm.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the yoke to control arm bolt (1).

Tighten the bolt to 180 N.m (133 lb ft).





3. Install the shock to yoke retaining bolt (2).
4. Install the shock yoke nut (1).

Tighten the nut to 90 N.m (66 lb ft).

5. Install the tire and wheel.
6. Lower the vehicle.