Heated Oxygen Sensor Replacement - Bank 1 Sensor 1

Heated Oxygen Sensor Replacement - Bank 1 Sensor 1

Removal Procedure

Notice: Refer to Oxygen Sensor Notice.

Important:
* Bank 1 on the LC3 engine is the right side of the engine while sitting in the driver seat.

* Sensor 1 is the sensor closest to the engine, or farthest forward towards the front of vehicle.

* A special anti-seize compound is used on the oxygen sensor threads. New service sensors should already have the compound applied to the threads. Coat the threads of a reused sensor with anti-seize compound P/N 5613695 or equivalent.




1. Remove the engine sight shield.
2. Remove the front air inlet housing panel.
3. Disconnect the oxygen sensor electrical connector (1) from the engine wiring harness connector at the rear of the right head.
4. Remove the wire harness from the bracket.
5. Note the wire routing and attachment points for reassembly.
6. Raise and support the vehicle. Refer to Vehicle Lifting.




7. Remove oxygen sensor from the exhaust manifold.

Installation Procedure

Notice: Refer to Fastener Notice.




1. Install the oxygen sensor in the exhaust manifold.

Tighten the heated oxygen sensor (HO2S) to 42 N.m (31 lb ft).

2. Lower the vehicle.




3. Route and attach the wiring as noted during disassembly.
4. Connect the oxygen sensor electrical connector (1) to the engine wiring harness connector at the rear of the right head.
5. Install the wire harness to the bracket.
6. Install the front air inlet housing panel.
7. Install the engine sight shield.