C0558

DTC C0558

DTC Descriptor

DTC C0558
- Calibration Data Not Programmed

Diagnostic Fault Information

Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

Circuit/System Description

The electronic suspension control (ESC) module performs checks of internal calibration data.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

Module calibration data is not programmed.

Action Taken When the DTC Sets

* ESC is disabled.
* SERVICE SUSPENSION SYSTEM and SPEED LIMITED message is displayed in the driver information center (DIC).

Conditions for Clearing the DTC

The condition is no longer present.

Circuit/System Verification

Verify that DTC C0558 is not current.

If the DTC is current, program the electronic suspension control module. If the DTC resets, replace the ESCM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Control Module References for ESCM replacement, setup, and programming