Operation CHARM: Car repair manuals for everyone.

Navigation System - Voice Recognition Inoperative



Navigation System - Voice Recognition Inoperative

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Testing

1. Verify the OnStar(R) voice recognition is operating normally.

If the OnStar(R) voice recognition is inoperative, refer to- Symptoms - Navigation Systems

2. Ignition OFF, disconnect the radio harness connector C2 and VCIM harness connector C3.
3. Test for less than 1 volt on the microphone out circuit radio harness connector terminal 4 and ground.

If greater than specified value, repair short to voltage.

4. Test for greater than 1 ohm between the microphone out circuit radio harness connector terminal 4 and ground.

If less than specified value, repair short to ground.

5. Test for less than 1 ohm between the low reference circuit radio harness connector terminal 4 and the low reference signal circuit VCIM harness connector terminal 2.
6. If greater than specified value, repair open circuit.
7. Test for less than 1 volt on the voice recognition audio signal circuit radio harness connector terminal 1 and ground.

If greater than specified value, repair short to voltage.

8. Test for greater than 1 ohm between the voice recognition audio signal circuit radio harness connector terminal 1 and ground.

If less than specified value, repair short to ground.

9. Test for less than 1 ohm between the voice recognition audio signal circuit radio harness connector terminal 1 and the voice recognition audio signal signal circuit VCIM harness connector terminal 2.

If greater than specified value, repair open circuit.

10. If all circuits test normal, replace the radio.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

* Steering Wheel Control Switch Assembly Replacement
* Programming and RelearningProgramming and Relearning
* Mobile Telephone Microphone Replacement. Verification Tests