Speedometer and/or Odometer Inaccurate or Inoperative
Speedometer and/or Odometer Inaccurate or Inoperative
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.
Diagnostic Fault Information
Circuit/System Description
The engine control module (ECM) creates the vehicle speed output signal by pulsing the circuit to ground at a rate of 4 KPPM. The VSS input is pulled high to B+ in the instrument panel cluster (IPC). The IPC converts the 4 KPPM vehicle speed signal to a speedometer position to indicate the vehicle speed. The ECM monitors the voltage at the vehicle speed output signal circuit to determine when the voltage is out of the normal operating range.
Circuit/System Verification
Start the engine with the scan tool installed, the vehicle drive wheels raised and the transmission placed in drive or the first gear. Refer to Vehicle Lifting. Verify the speedometer display does not match the scan tool Vehicle Speed parameter in the ECM Engine Data List.
Circuit/System Testing
Important: The drive wheels of the vehicle must be raised and the transmission must be placed in drive or first gear. Refer to Vehicle Lifting.
1. Ignition ON, with the scan tool installed, perform the IPC Gage Sweep Test in the IPC Output Controls. Verify the speedometer dial moves from the minimum to the maximum position and back to the speedometer minimum position.
• If the speedometer does not perform the IPC Gage Sweep Test, replace the IPC.
2. Ignition OFF, disconnect the C1 harness connector at the radio.
3. Start the engine, with the drive wheels raised and the vehicle placed in drive or the first gear. Verify that the speedometer value does not match the scan tool Vehicle Speed parameter in the ECM Engine Data List.
• If the speedometer matches the scan tool Vehicle Speed parameter, test the vehicle speed signal circuit terminal F2 for a short to voltage, a short to ground or an open/high resistance. If circuit tests normal, replace the radio.
4. Ignition OFF, disconnect the harness connector at the rear object sensor control module.
5. Start the engine, with the drive wheels raised and the vehicle placed in drive or the first gear. Verify that the speedometer value does not match the scan tool Vehicle Speed parameter in the ECM Engine Data List.
• If the speedometer matches the scan tool Vehicle Speed parameter, test the vehicle speed signal circuit terminal 18 for a short to voltage, a short to ground or an open/high resistance. If circuit tests normal, replace the object detection module.
6. Ignition OFF, disconnect the harness connector at the head-up display (HUD).
7. Start the engine, with the drive wheels raised and the vehicle placed in drive or the first gear. Verify that the speedometer value does not match the scan tool Vehicle Speed parameter in the ECM Engine Data List.
• If the speedometer matches the scan tool Vehicle Speed parameter, test the vehicle speed signal circuit terminal 11 for a short to voltage, a short to ground or an open/high resistance. If circuit tests normal, replace the HUD.
8. Ignition OFF disconnect the C1 harness connector at the engine control module.
9. Ignition ON, test for 9-11 volts between the vehicle speed signal circuit terminal 39 and ground.
• If less than 9 volts, test the vehicle speed signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the IPC.
• If greater than 11 volts, test the vehicle speed signal circuit for a short to voltage. If the circuit tests normal, replace the IPC.
10. If all circuits test normal, test or replace the ECM.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests
Programming and RelearningProgramming and Relearning