Headlamp Aiming (Export, LH Rule of the Road)

HEADLAMP AIMING (EXPORT, LH RULE OF THE ROAD)




Aiming the headlamps is done by turning the horizontal (1) and vertical (2) adjusting screws which move the headlamp bulb in relation to the headlamp assembly. The adjusting screws are located inboard of the front fender wheelhouse panel. The high beam will be correctly aimed if the low beam is aimed properly.

1. Prepare the aiming screen and the vehicle for headlamp aiming. Refer to Headlamp Aiming (Visual Method) Headlamp Aiming (Export, LH Rule of the Road) Headlamp Aiming (Export, RH Rule of the Road).
2. Raise the hood.




3. Turn ON the low beam lamps.
4. Inspect the horizontal aim.
5. Using the horizontal adjusting screw, align the break point (3) of the high intensity zone within the range of 38 mm (1.5 in) to the left (4) and to the right (5) of the lamp vertical centerline (1) on the aiming screen.
6. Inspect the vertical aim.
7. Using the vertical adjusting screw, align the upper edge of the horizontal cut off line 114 mm (4.5 in) below (7) the horizontal centerline (2), within the range of 76 mm (3 in) (8) and 191 mm (7.5 in) (6) below the centerline on the aiming screen.
8. Turn OFF the headlamps.
9. Lower the hood.