Intake Air Temperature (IAT) Sensor 2 Replacement

Intake Air Temperature (IAT) Sensor 2 Replacement

Removal Procedure




1. Remove the intake manifold sight shield.
2. Disconnect the intake air temperature (IAT) sensor 2 electrical connector.




3. Remove the IAT sensor 2 (1).

Installation Procedure

Notice: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.




1. Coat the sensor threads with sealer. Refer to Sealers, Adhesives, and Lubricants.

Notice: Refer to Fastener Notice.

2. Install the IAT sensor 2 (1).

Tighten the IAT sensor 2 to 20 N.m (15 lb ft).




3. Connect the IAT sensor 2 electrical connector.
4. Install the intake manifold sight shield.