Outside Temperature Display Sensor: Service and Repair

Ambient Air Temperature Gage Sensor Replacement

Removal Procedure

1. Remove the knee bolster.
2. Remove the driver information center retaining screw.
3. Disconnect driver information center from the instrument panel (I/P).
4. Disconnect the inside air temperature sensor from the driver information center (DIC) bezel.




5. Disconnect the inside air temperature sensor electrical connector.

Installation Procedure

1. Connect the inside air temperature sensor electrical connector.






Important: Ensure that the inside temperature sensor is fully seated into the DIC bezel.

2. Install the inside air temperature sensor.
3. Connect driver information center to the I/P.

Notice: Refer to Fastener Notice.

4. Install the driver information center retaining screw.

Tighten the screw to 1.9 N.m (17 lb in).

5. Install the knee bolster.