Steering Column Lock Control Module Replacement

Steering Column Lock Control Module Replacement

Removal Procedure




Caution: Refer to Restraint System Service Precautions.

1. Disable the SIR system. Refer to SIR Disabling and Enabling.

Notice: Avoid damaging the steering column electronic lock harness by gently removing the plugs installed in the I/P beam. Do NOT twist, pull, bend, cut, or incorrectly route the harness. Damage to the harness will require replacement of the entire electronic lock.

2. Remove the instrument panel (I/P) carrier.
3. Disconnect the electrical connectors at the lock module.




4. Remove the lock module by pulling the module up to release the retaining clips and sliding the module upward.

Installation Procedure




1. Install the control module to the retaining bracket on the steering column.
2. Connect the electrical connector to the lock module.




3. Install the I/P carrier.
4. Enable the SIR system. Refer to SIR Disabling and Enabling.
5. Program the lock control module. Refer to Programming and Relearning.Programming and Relearning