Flex Plate: Service and Repair

Engine Flywheel Replacement

Tools Required

J 45059 Angle Meter

Removal Procedure

1. Remove the powertrain.




2. Remove the driveline support assembly.
3. Use a Snap-On(TM) A144A Flywheel Turner, or equivalent to prevent the engine from turning.
4. Remove the engine flywheel bolts.
5. Remove the engine flywheel.
6. Clean and inspect the engine flywheel.

Installation Procedure

1. Apply sealant to the flywheel mounting bolts.




2. Position the flywheel to the crankshaft.

Notice: Refer to Fastener Notice.

3. Install the flywheel mounting bolts.
4. Use a Snap-On(TM) A144A Flywheel Turner, or equivalent to prevent the engine from turning.
1. First Pass
Tighten the flywheel mounting bolts to 30 N.m (22 lb ft).
2. Final Pass
Tighten the flywheel mounting bolts an additional 50 degrees using the J 45059.
5. Install the driveline support assembly.
6. Install the powertrain.