Power Mirror Motor: Service and Repair

OUTSIDE REARVIEW MIRROR MOTOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the door trim panel.




2. Disconnect the electrical connector to the mirror wire harness.
3. Remove the mirror face.
4. Remove the screws from the mirror motor.
5. Pull the motor electrical harness through the mirror housing.




6. Remove the motor from the mirror housing.

INSTALLATION PROCEDURE




1. Position the motor to the mirror housing.
2. Pull the motor electrical harness through the mirror housing to the inside door panel.

3. NOTE: Refer to Fastener Notice.

Install the screws to the mirror motor.

Tighten the mirror motor screws to 10 N.m (89 lb in).

4. Install the mirror face to the mirror housing.




5. Connect the electrical connector to the mirror wire harness.
6. Inspect the operation of the mirror.
7. Install the door trim panel.