Ignition Coil(s) Replacement - Bank 2

Ignition Coil Replacement - Bank 2

Removal Procedure




1. Remove the fuel injector sight shield.
2. Disconnect the ignition coil wiring harness electrical connector from the coil that is being replaced.




3. Remove the ignition coil retaining bolt.
4. Remove the ignition coil.

Installation Procedure






Important: Ensure that the spark plug seal is in place when installing the ignition coil.

1. Install the ignition coil.

Notice: Refer to Fastener Notice.

2. Install the ignition coil retaining bolt.

Using the installation torque sequence, tighten the ignition module retaining bolts to 10 N.m (89 lb in).

3. Reconnect the ignition coil electrical connector.
4. Install the fuel injector sight shield.