Tilt Wheel Switch: Service and Repair

Telescope Actuator Switch Replacement

Removal Procedure

Caution: Refer to Restraint System Service Precautions.

1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the knee bolster.




3. Remove the retaining screws (4) from the lower steering column trim cover.
4. Disconnect the lower trim cover from the closeout shroud.
5. Disconnect the telescope actuator switch electrical connector.
6. Remove the telescope actuator switch from the lower trim cover.

Installation Procedure




1. Install the telescope actuator switch to the lower steering column trim cover.
2. Connect the telescope actuator switch electrical connector to the steering column control module.
3. Connect the lower trim cover to the closeout shroud.

Notice: Refer to Fastener Notice.

4. Install the retaining screws (4) to the lower steering column trim cover.

Tighten the screws to 3 N.m (27 lb in).

5. Install the knee bolster.
6. Enable the SIR system. Refer to SIR Disabling and Enabling.