Starter Motor: Service and Repair

Starter Motor Replacement (LH2)

Removal Procedure

1. Disconnect the battery negative cable.
2. Remove the intake manifold.




3. Disconnect the BAT cable from the starter.
4. Disconnect the wire from the S terminal (4) on the starter.




5. Remove the 2 starter motor mounting bolts.
6. Remove the starter motor.

Installation Procedure




1. Install the starter motor.

Notice: Refer to Fastener Notice.

2. Install the starter motor mounting bolts.

Tighten the starter motor mounting bolts to 30 N.m (22 lb ft).

3. Connect the starter motor S terminal wire (4).

Tighten the starter solenoid S terminal nut to 4 N.m (35 lb in).

4. Connect the starter motor BAT terminal wire.

Tighten the battery cable to starter terminal nut to 12 N.m (106 lb in).

5. Install the intake manifold.
6. Connect the battery negative cable.