B101E
DTC B101E
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
DTC Descriptors
DTC B101E 42
- ECU Software Performance Calibration Data Set Not Programmed
Circuit/System Description
When the ignition is turned ON, the radio performs a self test to verify if any critical malfunction exists within the system. Once the power-up mode is completed, the radio establishes communications with the body control module (BCM). During the power-up mode the radio checks for a valid calibration data set, if no valid calibration set is found the radio disables the system.
Conditions for Running the DTC
* The ignition must be in the RUN or ACC position.
* The system voltage is at least 9.5 volts and no more than 15.5 volts.
* All the above conditions are present for greater than 10 seconds.
Conditions for Setting the DTC
The calibration data set is not programmed in the radio.
Action Taken When the DTC Sets
The radio refuses all user inputs.
Conditions for Clearing the DTC
* A current DTC clears when the conditions for setting the DTC are no longer present.
* A history DTC clears after 50 malfunction-free ignition cycles.
* The radio receives a clear command code from the scan tool.
Reference Information
Schematic Reference
Radio/Navigation System Schematics (Radio/Navigation System Schematics)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Radio/Audio System Description and Operation (Radio/Audio System Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Testing
Ignition ON, scan tool installed, verify that DTC B101E is a history code.
If DTC B101E is current, perform the programming and setup procedure for the radio.