Operation CHARM: Car repair manuals for everyone.

B1722



DTC B1722

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview)provides an overview of each diagnostic category.



DTC Descriptors
DTC B1715 02
- Mirror Power Fold Control Switch Circuit Short to Ground




Diagnostic Fault Information






Circuit/System Description

The Driver Door Module (DDM) and Passenger Door Module (PDM) control the power folding or power extending functions of the outside rearview mirrors. The folding mirror motors are controlled by using bi-directional motor controls through the folding mirror motor retract control circuit and the folding mirror motor extend control circuit.


Conditions for Running the DTC

Mirror folding is requested.


Conditions for Setting the DTC

An improper voltage level is seen on either the folding mirror motor retract control circuit or the folding mirror motor extend control circuit.


Action Taken When the DTC Sets

Power folding mirror operations are suspended so long as the fault is present.


Conditions for Clearing the DTC

* A current DTC will clear when the fault is no longer present.
* A history DTC will clear after 40 malfunction-free ignition cycles.



Reference Information
Schematic Reference

Outside Rearview Mirror Schematics (Outside Rearview Mirror Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Outside Mirror Description and Operation (Outside Mirror Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool References

Control Module References (Programming and Relearning)For Scan Tool Information.


Circuit/System Verification

Ignition ON, using the folding mirror switch, the left and right rearview mirrors should extend and retract as commanded.


Circuit/System Testing

1. Ignition OFF, disconnect the inline harness connector at the appropriate door module.
2. Ignition ON, verify a test lamp does not illuminate between the following circuit terminals and ground:

* Control circuit terminal 1
* Control circuit terminal 2


If the test lamp illuminates, test the appropriate circuit for a short to voltage.

3. Ignition OFF, test for infinite resistance between the following circuits and ground:

* Control circuit terminal 1
* Control circuit terminal 2


If less than the specified value, test the appropriate circuit for a short to ground. If the circuits test normal, test or replace the rearview mirror motor.

4. Test for 5-15 ohms of resistance between the control circuit terminal 1 and the control circuit terminal 2.

If not within the specified range, test both control circuits for an open/high resistance. If the circuits test normal, test or replace the rearview mirror motor.

5. If all circuits test normal, replace the appropriate door module.



Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Outside Rearview Mirror Motor Replacement (Service and Repair)
* Control Module References (Programming and Relearning)for DDM or PDM replacement, setup, and programming