Electronic Brake Control Module Programming and Setup

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:

* EBCM Reprogramming-Refer to Service Programming System (SPS) (Programming and Relearning) .
* Recalibrate the brake pedal position (BPP) sensor. Refer to Brake Pedal Position Sensor Replacement (Brake Pedal Position Sensor Replacement) .
* Recalibrate the steering angle position sensor. Refer to Steering Angle Sensor Centering (Procedures) .
* Recalibrate the yaw rate sensor.