B101E

DTC B101E

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptor
DTC B101E 4A
- ECU Software Performance Checksum Error

DTC B101E 4B
- ECU Software Performance Calibration Not Learned




Circuit/System Description

The vehicle alert alarm warning (VDAAW) system consists of a lane departure warning (LDW) module mounted on the windshield. The VDAAW is enabled and disabled through a toggle switch located in the headlamp switch assembly. When enabled, the VDAAW will illuminate the indicator located in the toggle switch. A camera located in the LDW module is used to locate lane markings in the road. When the system is working and can detect the lane markings the VDAAW will illuminate the lane departure warning indicator in the instrument panel cluster (IPC). The IPC indicator will illuminate green when the system is operating properly and will illuminate and flash amber when the vehicle crosses a lane marking without the turn signal being used. An audible warning will also sound three times when the IPC indicator is flashing. The VDAAW system communicates with the IPC via serial data.


Conditions for Running the DTC

Battery voltage must be between 9-16 volts.


Conditions for Setting the DTC

B101E 4A

This DTC will set when the ECU detects a memory checksum mismatch.

B101E 4B

This DTC will set when the ECU detects a calibration failure.


Action Taken When the DTC Sets

The ECU will disable the VDAAW feature.


Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.
* You issue a scan tool CLEAR DTCs command.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.



Reference Information
Schematic Reference

Object Detection Schematics ([1][2]Collision Avoidance and Parking Assist Systems)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Object Detection Description and Operation (Rear Park Assist) (Object Detection Description and Operation (Rear Park Assist))Object Detection Description and Operation (VDAAW) (Object Detection Description and Operation (VDAAW))Object Detection Description and Operation (SOD) (Object Detection Description and Operation (SOD))
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Programming and Relearning (Programming and Relearning) for scan tool information


Circuit/System Verification

B101E 4A

With the scan tool, clear DTC B101E 4A.

If DTC B101E 4A does not clear or if it resets, replace the VDAAW module.


B101E 4B

With the scan tool, verify DTC B101E 4B is not set.

If DTC B101E 4B is set, refer to Vehicle Direction Alert Alarm Warning Module Calibration (Procedures) .



Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.


Programming and Relearning (Programming and Relearning) for VDAAW replacement, setup, and programming