Steering Wheel Controls Inoperative

Steering Wheel Controls Inoperative

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview)provides an overview of each diagnostic category.



Circuit/System Description

The body control module (BCM) supplies voltage to the audio steering wheel control multiple momentary contact switches and monitors the return signal. Each switch is associated to a set resistance value, when pressed a specific voltage drop occurs through a series of resistors unique to that switch. The BCM identifies the selection, then sends a serial data message that is received by the component controlled, activating the feature.


Diagnostic Aids

* This diagnostic is for the audio steering wheel controls.
* Before diagnosis of the steering wheel controls, ensure the primary controls of the associated component are functioning properly.
* If a single switch function is inoperative, test the suspect switch. Refer to component testing.



Reference Information
Schematic Reference

Steering Wheel Secondary/Configurable Control Schematics (Steering Wheel Secondary/Configurable Control Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Steering Wheel Controls Description and Operation (Steering Wheel Controls Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Programming and Relearning (Programming and Relearning)for Scan Tool Information


Circuit/System Verification

Ignition ON, observe the BCM data display with the scan tool under Inputs-SWC Bank 1 status. Data displays SW1-SW7 identifying the switch pressed, and Idle when released.


Circuit/System Testing

Important: It is recommended that component testing is performed before circuit testing when diagnosing steering wheel controls.



1. Ignition OFF, disconnect the harness connector at the right steering wheel control switch.
2. Ignition ON, test for ignition voltage between the ignition circuit terminal 3 and ground.

• If less than the specified value, test the ignition circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the BCM.

3. Test for the 0 volts between the signal circuit terminal 4 and ground.

• If greater than the specified value, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.

4. Test for ignition voltage between the ignition circuit terminal 3 and the signal circuit terminal 4.

• If less than the specified value, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the BCM.

5. Ignition OFF, disconnect the harness connector X1 at the BCM.
6. Test for infinite resistance between the signal circuit terminal 6 and ground.

• If less than the specified value, test the signal circuit for a short to ground.

7. If all circuits test normal, test or replace the steering wheel control switch.



Component Testing

1. Ignition OFF, disconnect the harness connector at the right steering wheel control switch.
2. Test for infinite resistance between the ignition terminal 3 and the signal terminal 6 with the switch in the open position.

• If less than the specified value, replace the steering wheel control switch.

3. Test for less than 5,400 ohms between the ignition terminal and the signal terminal with the switch closed in each position.

• If greater than the specified range, replace the steering wheel control switch.




Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Steering Wheel Control Switch Assembly Replacement (Service and Repair)
* Programming and Relearning (Programming and Relearning)for BCM replacement, setup, and programming