Operation CHARM: Car repair manuals for everyone.

Antilock Brake System



DTC C0558

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptor
DTC C0558
- Calibration Data Not Programmed/Learned




Circuit/System Description

The electronic brake control module (EBCM) must be calibrated.


Conditions for Running the DTC

* The ignition is ON.
* Ignition voltage is greater than 8 volts.



Conditions for Setting the DTC

The EBCM has not been calibrated.


Actions Taken When DTC Sets

* The EBCM disables the ABS and the TCS for the duration of the ignition cycle.
* The ABS indicator turns ON.



Conditions for Clearing the DTC

* The condition for the DTC is no longer present and the DTC is cleared with a scan tool.
* The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.



Reference Information
Schematic Reference

Antilock Brake System Schematics (Except JL7) (Antilock Brake System Schematics (Except RPO JL7))Antilock Brake System Schematics (JL7) (Antilock Brake System Schematics (With RPO JL7))
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Without JL7) (ABS Description and Operation (Without RPO JL7))ABS Description and Operation (With JL7) (ABS Description and Operation (With RPO JL7))
Electrical Information Reference

* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for Scan Tool information.


Circuit/System Verification

Calibrate the EBCM. Refer to Control Module References (Programming and Relearning) .


Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.


Control Module References (Programming and Relearning) for EBCM calibration