Power Steering Control Module Programming and Setup
Power Steering Control Module Programming and Setup
Power Steering Control Module (PSCM) Replacement and Setup
The following service procedures require either a programming or a setup event performed for a complete repair.
If the power steering control module (PSCM) is replaced, the following procedures must be performed in the following order:
* PSCM Reprogramming-Refer to Service Programming System (SPS) (Programming and Relearning) .
* Revise the new actuator setup procedure using the Scan Tool setup function.
* Revise the actuator removal procedure using the Scan Tool setup function.
* Revise the steering angle position sensor procedure using the Scan Tool setup function.