Remote Control Door Lock Receiver Programming and Setup (Europe)

Remote Control Door Lock Receiver Programming and Setup (Europe)

Remote Control Door Lock Receiver

If the remote control door lock receiver (RCDLR) is replaced, the following procedures must be performed in the order listed below:

1. Perform the Keyless Entry Transmitter Programming procedure. Refer to Transmitter Programming (North America, except Canada) (Programming and Relearning)Transmitter Programming (Canada, Europe, Asia, Middle East) (Programming and Relearning) , using Method 2 to perform the programming.
2. Perform the procedure to set up a new RCLDR:

1. Connect the Tech 2 to the vehicle.
2. Select RCDLR under Module Setup in the Vehicle Control System menu.
3. Select Setup New RCDLR.
4. Follow the on-screen instructions.


Important: The 10-Minute Immobilizer Relearn procedure for the SCLM must be done first. Failure to do so may result in complications when attempting to perform the 10-Minute Immobilizer Relearn procedure for the ECM.


3. Perform the 10-Minute Immobilizer Relearn procedure for the SCLM. Refer to Immobilizer System Component Programming (Programming and Relearning) .
During the SCLM programming, select Theft Deterrent Learn for Column Lock Module (Export Only) on the SPS terminal.
4. Perform the 10-Minute Immobilizer Relearn procedure for the ECM. Refer to Immobilizer System Component Programming (Programming and Relearning) .
When performing the relearn procedure, select Theft Deterrent Learn for ECM (Export Only) on the SPS terminal.
5. Perform the Tire Pressure Sensor Learn procedure. Refer to Tire Pressure Sensor Learn Programming and Relearning