B0051

DTC B0051

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptor
DTC B0051
- Deployment Commanded




Circuit/System Description

The inflatable restraint sensing and diagnostic module (SDM) contains sensing devices that converts vehicle velocity changes to electrical signals. The SDM processes the generated electrical signals and compares them to values stored in memory. When the generated signals exceed the stored values, the SDM performs additional signal processing and compares the generated signals to signals stored in memory. When 2 of the generated signals exceed the stored values, the SDM will cause current to flow through the inflator modules, deploying the inflator modules, and causing DTC B0051 to set.


Conditions for Running the DTC

Ignition voltage is between 9-16 volts.


Conditions for Setting the DTC

* The SDM detects a frontal impact of sufficient force to warrant deployment of the frontal modules.
* The SDM detects a side impact of sufficient force to warrant deployment of a side impact module.



Action Taken When the DTC Sets

* The SDM commands the AIR BAG warning lamp ON via serial data communication.
* The SDM records crash data.



Conditions for Clearing the DTC

DTC B0051 is a latched code. You cannot clear a latched code. Replace the SDM after following the instructions.


Reference Information
Schematic Reference

SIR Schematics ([1][2]Air Bag Systems)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

SIR System Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
* SIR/SRS Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information


Circuit/System Testing

With a scan tool, verify DTC B0051 is not set.

If DTC is set, replace the SDM.



Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* SIR/SRS Wiring Repairs (Component Tests and General Diagnostics)
* Control Module References (Programming and Relearning) for SDM replacement, setup, and programming