Operation CHARM: Car repair manuals for everyone.

B2465



DTC B2465

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptor
DTC B2465
- Navigation Compact Disk Player - Data Error




Circuit Description

The circuitry is internal to the navigation radio. The system does not function when an incorrect CD or DVD is inserted into the navigation system.


Conditions for Running the DTC

* Radio ON.
* Battery voltage must be between 9-16 volts.



Conditions for Setting the DTC

The navigation radio has determined an incorrect CD has been inserted.


Action Taken When the DTC Sets

* No map appears on the display.
* Navigation buttons do not function.
* PLEASE INSERT MAP DVD message appears on the display.



Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 50 consecutive malfunction-free ignition cycles have occurred.



Reference Information
Schematic Reference

Radio/Navigation System Schematics (Radio/Navigation System Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Navigation System Description and Operation (Navigation System Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning)for scan tool information


Circuit/System Testing

Important: The DVD installed must be a map DVD as defined for this system.



1. Ignition ON, with a scan tool clear all DTCs.
2. Ignition ON, install a known good MAP DVD and operate the system within the Condition for Running the DTC.

If the DTC resets, replace the radio.




Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.


Control Module References (Programming and Relearning)for Radio replacement, setup, and programming