Operation CHARM: Car repair manuals for everyone.

C0250



DTC C0249 or C0250

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview)provides an overview of each diagnostic category.



DTC Descriptors
DTC C0249
- Left Normal Force Error

DTC CO250
- Right Normal Force Error




Circuit/System Description

The electronic brake control module (EBCM) receives invalid information from other modules through the GMLAN serial data bus. The EBCM will set DTC based on this information.


Conditions for Running the DTC

* The ignition is ON.
* Ignition voltage is greater than 8 volts.



Conditions for Setting the DTC

The EBCM receives invalid information from other modules.


Action Taken When the DTC Sets

* The EBCM operates normal.
* The antilock brake system (ABS), traction control off, and brake indicator lights remain OFF.



Conditions for Clearing the DTC

* The condition for the DTC is no longer present and the DTC is cleared with a scan tool.
* The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.



Diagnostic Aids

This DTC is for information only. As an aid to the technician, this DTC indicates that there are no problems in the ABS.


Reference Information
Schematic Reference

Antilock Brake System Schematics ([1][2]Antilock Brakes / Traction Control Systems)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning)for Scan Tool Information


Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.