Radio Replacement

Radio Replacement

Removal Procedure





1. Remove the cover from the I/P electrical center.
2. Remove the RDO/CD MiniFuse(R) #5 from the I/P electrical center.
3. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Service and Repair) .
4. Remove the screws retaining the radio control to the I/P center support bracket.
5. Begin to remove the radio control from the center support bracket enough to access the connectors at rear of the radio control.
6. Disconnect the electrical/audio and coaxial cable connectors from the radio control.
7. Remove the radio control.
8. Remove the retaining bolts from the radio mounting bracket. Remove the bracket from the radio.



Installation Procedure


Notice: Refer to Fastener Notice (Fastener Notice) .

1. Install the mounting bracket to the radio and secure with the retaining bolts.

Tighten the bolts to 2.5 N.m (22 lb in).

2. Connect the electrical/audio and coaxial cable connectors to the radio control.
3. Install the radio control into position in the I/P center support bracket.
Align the radio control locator tab into the center support bracket locator hole.





Notice: Refer to Fastener Notice (Fastener Notice) .

4. Install the radio control retaining screws.

Tighten the screws to 2.5 N.m (22 lb in).

5. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Service and Repair) .
6. Install the RDO/CD MiniFuse(R) #5 to the I/P electrical center.
7. Install the cover to the I/P electrical center.
8. Refer to Control Module References (Programming and Relearning) for programming and setup information.