100. Oil Pan Installation

Oil Pan Installation





1. Place a NEW oil pan gasket in place on the oil manifold plate.




2. Position the oil pan onto the lower crankcase.




3. The oil pan must be held flush to 0.50 mm (0.020 in) forward of the rear face of the engine block (1).




4. Install the oil pan bolts in the sequence shown.

1. First Pass

Tighten the oil pan bolts to 15 N.m (11 lb ft ) in the sequence shown.

2. Final Pass

Tighten the oil pan bolts to 25 N.m (18 lb ft ) in the sequence shown.


5. Clean off any sealant that has protruded to the exterior of the engine.
6. Install the oil drain plug.

Tighten the oil drain plug to 25 N.m (18 lb ft).

7. Rotate the engine so that the engine valley is facing upward.