1. Engine Wiring Harness Assembly Removal
Engine Wiring Harness Assembly Removal
Left Side Harness Connections
1. Disconnect the engine wiring harness from the left side fuel injectors.
2. Disconnect the engine wiring harness from the left camshaft cover.
3. Disconnect the engine wiring harness from the left ignition coil harness.
4. Disconnect the engine wiring harness from the left camshaft position sensors.
5. Disconnect the engine wiring harness from the EVAP purge solenoid.
6. Disconnect the engine wiring harness from the throttle position sensor on the throttle body.
7. Remove the nut attaching the starter motor wiring harness to the generator stud.
8. Disconnect the starter motor wiring harness from the generator stud.
9. Disconnect the engine wiring harness from the generator.
10. Disconnect the engine wiring harness from the oil pressure sensor.
11. Disconnect the engine wiring harness from the oxygen sensor wiring harness.
12. Disconnect the engine wiring harness from the starter motor wiring harness.
13. Remove the bolt and nut retaining the engine wiring harness to the engine block.
14. Remove the engine wiring harness ground bolt at the front of the engine block.
15. Remove the engine wiring harness ground bolt at the rear of the engine block.
16. Remove the bolt retaining the engine wiring harness to the left camshaft position actuator housing.
Right Side Harness Connections
1. Disconnect the engine wiring harness from the right side fuel injectors.
2. Disconnect the engine wiring harness from the right camshaft cover.
3. Disconnect the engine wiring harness from the right ignition coil harness.
4. Disconnect the engine wiring harness from the right camshaft position sensors.
5. Remove the engine wiring harness ground nut from the fuel rail stud.
6. Remove the engine wiring harness ground from the fuel rail stud.
7. Disconnect the engine wiring harness from the ECT sensor at the rear of the right cylinder head.
8. Disconnect the engine wiring harness from the air conditioning compressor.
9. Disconnect the engine wiring harness from the MAP sensor.
10. Disconnect the engine wiring harness from the knock and crankshaft position sensor wiring harness.
11. Disconnect the engine wiring harness from the oil level sensor.
12. Disconnect the engine wiring harness from the right oxygen sensor wiring harness.
13. Remove the engine wiring harness bracket bolt from the engine block.
14. Remove the engine wiring harness from the engine.