141. Engine Wiring Harness Assembly Installation

Engine Wiring Harness Assembly Installation

Left Side Harness Connections





1. Install the engine wiring harness to the engine.




2. Connect the engine wiring harness to the left side fuel injectors.




3. Connect the engine wiring harness to the left camshaft cover.




4. Connect the engine wiring harness to the left ignition coil harness.




5. Connect the engine wiring harness to the left camshaft position sensors.




6. Connect the engine wiring harness to the EVAP purge solenoid.




7. Connect the engine wiring harness to the throttle position sensor on the throttle body.





Notice: Refer to Fastener Notice (Fastener Notice) .

8. Connect the starter motor wiring harness to the generator stud.
9. Install the nut attaching the starter motor wiring harness to the generator stud.

Tighten the generator stud nut to 20 N.m (15 lb ft).





10. Connect the engine wiring harness to the generator.




11. Connect the engine wiring harness to the oil pressure sensor.




12. Connect the engine wiring harness from the oxygen sensor wiring harness.




13. Connect the engine wiring harness to the starter motor wiring harness.




14. Install the bolt and nut retaining the engine wiring harness to the engine block.

Tighten the engine wiring harness bolt and nut to 35 N.m (26 lb ft).

15. Install the engine wiring harness ground bolt at the front of the engine block.

Tighten the engine wiring harness ground bolt to 35 N.m (26 lb ft).





16. Install the engine wiring harness ground bolt at the rear of the engine block.

Tighten the engine wiring harness ground bolt to 12 N.m (106 lb in).





17. Install the bolt retaining the engine wiring harness to the left camshaft position actuator housing.

Tighten the engine wiring harness bolt to 35 N.m (26 lb ft).




Right Side Harness Connections





1. Connect the engine wiring harness to the right side fuel injectors.




2. Connect the engine wiring harness to the right camshaft cover.




3. Connect the engine wiring harness to the right ignition coil harness.




4. Connect the engine wiring harness to the right camshaft position sensors.




5. Install the engine wiring harness ground to the fuel rail stud.
6. Install the engine wiring harness ground nut to the fuel rail stud.

Tighten the engine wiring harness ground nut to 8 N.m (71 lb in).





7. Connect the engine wiring harness to the ECT sensor at the rear of the right cylinder head.




8. Connect the engine wiring harness to the air conditioning compressor.




9. Connect the engine wiring harness to the MAP sensor.




10. Connect the engine wiring harness to the knock and crankshaft position sensor wiring harness.




11. Connect the engine wiring harness to the oil level sensor.




12. Connect the engine wiring harness to the right oxygen sensor wiring harness.




13. Install the engine wiring harness bracket bolt to the engine block.

Tighten the engine wiring harness bracket bolt to 35 N.m (26 lb ft).