Instrument Cluster Head Up Display Replacement

Instrument Cluster Head Up Display Replacement

Removal Procedure





Caution: Refer to Battery Disconnect Caution .
1. Disconnect the negative battery cable.
2. Remove the I/P carrier. Refer to Instrument Panel Carrier Replacement (Service and Repair) .
3. Carefully lift the head-up display (HUD) electrical harness from between the instrument panel cluster (IPC) and the HUD.
4. Disconnect the HUD electrical connector from the IPC.




5. Remove the retaining screws that secure the IPC to the steering column bracket.
6. Raise the rear of the IPC slightly to release the locator tab. Reposition the IPC to access the retaining screw that secures the HUD to the steering column bracket.




7. Loosen the retaining screw that secures the HUD to the steering column bracket.
8. Remove the HUD retaining nuts.
9. Remove the HUD from the vehicle.



Installation Procedure





1. Transfer the retaining screw and nut to the replacement HUD.
2. Install the HUD to the vehicle:

1. Install the HUD onto the dash panel mounting studs.
2. Slide the HUD retaining screw into the slot on the steering column bracket.


Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the HUD retaining nuts.

Tighten the nuts to 5 N.m (44 lb in).

4. Tighten the screw that retains the HUD to the steering column bracket.

Tighten the screw to 3 N.m (27 lb in).





5. Install the retaining screws that secure the IPC to the steering column bracket .

Tighten the screws to 3 N.m (27 lb in).





6. Connect the HUD electrical connector to the IPC.
7. Carefully secure the HUD electrical harness (1) down between the IPC and the HUD as shown.
8. Install the I/P carrier. Refer to Instrument Panel Carrier Replacement (Service and Repair) .
9. Connect the negative battery cable.

Tighten the cable bolt to 15 N.m (11 lb ft).

10. Refer to Control Module References (Programming and Relearning) for programming and setup information.