Fog/Driving Lamp Bulb: Service and Repair

Front Fog Lamp Bulb Replacement

Removal Procedure

1. Remove the wheelhouse panel. Refer to Wheelhouse Panel Replacement - Left Side (Service and Repair) .
2. Disconnect the front fog lamp electrical connector from the fog lamp bulb/socket.





Caution: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:

* Turn off the lamp switch and allow the bulb to cool before changing the bulb.
* Leave the lamp switch OFF until the bulb change is complete.
* Always wear eye protection when changing a halogen bulb.
* Handle the bulb only by its base. Avoid touching the glass.
* Keep dirt and moisture off the bulb.
* Properly dispose of the used bulb.
* Keep halogen bulbs out of the reach of children.


3. Remove the fog lamp bulb/socket from the fog lamp by rotating the bulb/socket counterclockwise (1).




4. Remove the fog lamp bulb/socket (1).



Installation Procedure





1. Install the bulb/socket (1) to the fog lamp.




2. Rotate the bulb/socket clockwise (1) until the bulb/socket is fully seated.
3. Connect the front fog lamp electrical connector to the fog lamp bulb/socket.
4. Inspect the fog lamp for proper operation.
5. Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement - Left Side (Service and Repair) .
6. Aim the fog lamp. Refer to Fog Lamp Aiming (Procedures) .