Air Bag Control Module: Service and Repair
Inflatable Restraint Sensing and Diagnostic Module Replacement
Removal Procedure
Caution: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
Caution: Refer to SIR Caution (SIR Caution) .
1. Disable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair) .
2. Remove the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Service and Repair) .
3. Remove the connector position assurance (CPA) from the SDM harness connector.
4. Disconnect the SDM harness connector.
5. Remove the SDM mounting fasteners.
6. Remove the SDM from the I/P center support system.
Installation Procedure
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Install the SDM horizontally to the I/P center support system.
3. Point the arrow on the SDM toward the front of the vehicle.
Notice: Refer to Fastener Notice (Fastener Notice) .
4. Install the SDM mounting fasteners.
Tighten the fasteners to 10 N.m (89 lb in).
5. Install the SDM harness connector to the SDM.
6. Install the CPA to the SDM harness connector.
7. Install the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Service and Repair) .
Important: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly to ensure that the SDM is set properly.
8. Enable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair) .
9. Refer to Control Module References (Programming and Relearning) for programming and setup information.