Front Side Door Handle Switch Replacement

Front Side Door Handle Switch Replacement

Removal Procedure

This procedure covers the removal of either the driver or the passenger door release electric touch pad.

1. Open the door by using the touch pad or the floor mounted actuator.




2. Remove the fasteners (3) from the touch pad (1).
3. Remove the touch pad from the mounted position.
4. Disconnect the electrical connector (2).
5. Remove the touch pad.



Installation Procedure

1. Connect the touch pad electrical connector (2).




2. Position the touch pad onto the door.

Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the fasteners (3).

Tighten the fasteners to 2 N.m (18 lb in).

4. Verify the operation of the electric touch pad door release.