Manifold Pressure/Vacuum Sensor: Service and Repair

Manifold Absolute Pressure Sensor Replacement

Removal Procedure





1. Turn the ignition OFF.
2. Disconnect the MAP sensor electrical connector.
3. Remove the MAP sensor from the intake manifold.
4. Inspect the MAP sensor grommet for wear or damage. If a problem is found, replace as necessary.



Installation Procedure






Notice: Refer to Fastener Notice (Fastener Notice) .

1. Install the MAP sensor into the intake manifold.

Tighten the bolt to 12 N.m (106 lb in).

2. Connect the MAP sensor electrical connector.