Operation CHARM: Car repair manuals for everyone.

B1024




DTC B1024

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptor
DTC B1024 11
- Circuit Board Temperature Sensor Above Maximum Threshold

DTC B1024 53
- Circuit Board Temperature Sensor Low

DTC B1024 54
- Circuit Board Temperature Sensor High

Circuit/System Description

The internal module circuitry temperature is monitored. If the an over-heat condition which exceeds the maximum threshold of the internal circuitry or a malfunctioning temperature sensor is detected, the module will shut down until the internal circuitry cools.

Conditions for Running the DTC

* The radio is in the ON or ACCY position
* The system voltage is at least 9 volts and no more than 16 volts.

Conditions for Setting the DTC

The module detects an over-heat condition or a malfunctioning sensor.

Action Taken When the DTC Sets

Module functionality is suspended.

Conditions for Clearing the DTC

* A current DTC clears when the module temperature returns to an acceptable level.
* A history DTC clears after 100 malfunction-free ignition cycles.

Diagnostic Aids

Extended use of extremely high volume, especially in warm weather conditions, may cause this DTC to set in the audio amplifier. Under these conditions, it may be normal for this DTC to set to prevent permanent damage to the amplifier circuitry and no repair should be attempted.

Reference Information
Schematic Reference

Radio/Navigation System Schematics (Radio/Navigation System Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Radio/Audio System Description and Operation (Radio/Audio System Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Circuit/System Verification

Verify that DTC B1024 is not set.

If the DTC is set, replace the appropriate control module that set the DTC.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for audio amplifier or antenna module replacement, setup, and programming