Operation CHARM: Car repair manuals for everyone.

C028D




DTC C028D

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provide an overview of each diagnostic category.

DTC Descriptors
DTC C028D 00
- Replace Park Brake Pad Malfunction

Circuit/System Description

The electronic park brake control module has an internal motor, apply actuator, release actuator, and temperature sensor. The electronic park brake control module also contains the logic for applying and releasing the park brake when commanded by the electronic park brake switch. When the electronic park brake control module receives a signal from the switch the internal circuit board temperature is checked to verify it is within operating range before the control module performs the requested operation.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC

The electronic park brake control module detects a park brake pad malfunction.

Action Taken When the DTC Sets

A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The electronic park brake control module clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.
* Replace the park brake pads.

Reference Information
Schematic Reference

Park Brake System Schematics ([1][2]Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Electronic Parking Brake Control Module Description (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Verify DTC C028D is not set.

If DTC is set, replace the brake pad.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for electronic park brake control module replacement, setup, and programming.