Windows: Adjustments

Door Window Adjustment




Warning: Refer to Glass and Sheet Metal Handling Warning (Glass and Sheet Metal Handling Warning).

Warning: Refer to Express Window Down Warning (Service Precautions).

1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement (Service and Repair) or Rear Side Door Trim Panel Replacement (Service and Repair).
2. Pull down the upper portion of the water deflector far enough to access the window clamp nuts.
3. Loosen the window regulator to window clamp nuts 4 revolutions.
4. Connect the door trim panel wire connector.

Note: Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.

5. Start the vehicle.

Caution: Refer to Fastener Caution (Fastener Caution).

6. Using the power window switch, raise the window to the full up position. Tighten the window clamp nuts to 11 Nm (98 lb in).
7. Inspect for proper window operation and a tight seal.
8. Shut off the vehicle.
9. Install the water deflector.
10. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement (Service and Repair) or Rear Side Door Trim Panel Replacement (Service and Repair).