Heated Oxygen Sensor Replacement - Bank 1 Sensor 1

Heated Oxygen Sensor Replacement - Bank 1 Sensor 1

Removal Procedure





Caution: Refer to Fuel and Evaporative Emission Hose/Pipe Connection Cleaning Caution (Service Precautions).

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Disconnect the heated oxygen sensor (HO2S) electrical connector.
3. Remove any wire harness retainers and note the wire harness routing for reassembly.
4. Carefully remove the HO2S (1).

Installation Procedure





Note: Use special anti-seize compound on the HO2S threads. The compound consists of graphite suspended in fluid and glass beads. The graphite burns away, but the glass beads remain, making the sensor easier to remove. New or service sensors already have the compound applied to the threads. If you remove an oxygen sensor and if for any reason you must reinstall the same oxygen sensor, apply the anti-seize compound to the threads before reinstallation.

1. Coat the threads of the HO2S with the anti-seize compound P/N 5613695, or the equivalent if necessary.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the HO2S (1) and tighten to 41 Nm (30 lb ft).
3. Connect the HO2S electrical connector.
4. Route and attach the wire harness as noted during disassembly.
5. Lower the vehicle.