130. Starter Installation

Starter Installation

1. If installing a NEW starter motor, transfer the cables from the old starter motor.
2. Install the positive battery cable to the starter motor stud.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the starter motor stud nut and tighten to 9.5 Nm (84 lb in).
4. Install the solenoid wiring harness to the starter solenoid stud.
5. Install the starter solenoid stud nut and tighten to 3.4 Nm (30 lb in).




6. Position the starter motor in position.
7. Install the starter motor bolts and tighten to 30 Nm (22 lb ft).




8. Install a NEW O-ring on the crankshaft position sensor.




9. Install the crankshaft position sensor.
10. Install the crankshaft position sensor bolt and tighten to 10 Nm (89 lb in).




11. Install the knock sensors.
12. Install the knock sensor bolts and tighten to 10 Nm (89 lb in).




13. Install the knock and crankshaft position sensor wiring harness.
14. Connect the knock and crankshaft position sensor wiring harness brackets to the center, back and front of the block valley.




15. Install the knock and crankshaft position sensor wiring harness bolt (1) and tighten to 10 Nm (89 lb in).
16. Connect the knock and crankshaft position sensor wiring harness to the knock sensors and crankshaft position sensor.




17. Install the ECT sensor to the right cylinder head and tighten to 20 Nm (15 lb ft).