Tightening Torques & Sequences
CYLINDER HEADLeft:
Right:
Cylinder Head Bolt M11
First Pass - In Sequence 30 Nm (22 lb ft)
Second Pass - In Sequence 60 degrees
Third Pass - In Sequence 60 degrees
Fourth Pass - In Sequence 60 degrees
Final Pass - In Sequence 40 degrees, total 220 degrees
Cylinder Head Bolt M6 12 Nm (106 lb in)
CYLINDER HEAD BOLT RE-USABILITY
Notice: DO NOT reuse the old M11 cylinder head bolts.
CAMSHAFT BEARING CAP
Exhaust Camshaft - Left Side:
Intake Camshaft - Left Side:
Exhaust Camshaft - Right Side:
Intake Camshaft - Right Side:
Camshaft Bearing Cap Bolt
First Pass 5 Nm (44 lb in)
Final Pass 30 degrees
MAIN BEARING CAP
Lower Crankcase
Bearing Bolt
M10 x 1.5 First Pass - In Sequence 20 Nm (15 lb ft)
M10 x 1.5 Final Pass - In Sequence 65 degrees
Perimeter Bolt
M8 x 1.25 - In Sequence 30 Nm (22 lb ft)
ROD BEARING CAP
Connecting Rod Bolt
First Pass 30 Nm (22 lb ft)
Second Pass Back off to zero
Third Pass 25 Nm (18 lb ft)
Final Pass 110 degrees
CRANKSHAFT PULLEY
Crankshaft Balancer Bolt
First Pass 100 Nm (74 lb ft)
Final Pass 150 degrees
FLYWHEEL/FLEXPLATE
Engine Flywheel Bolt
First Pass 30 Nm (22 lb ft)
Final Pass 50 degrees
OIL PUMP
Oil Pump Cover Bolt 12 Nm (106 lb in)
Oil Pump Mounting Bolt
First Pass 10 Nm (89 lb in)
Final Pass 35 degrees
EXHAUST MANIFOLD
Right:
Left:
Exhaust Manifold Bolt and Nut 25 Nm (18 lb ft)
Stud into Cylinder Head 6 Nm (53 lb in)
WATER PUMP
Water Pump Bolt 10 Nm (89 lb in)