P0700
DTC P0700
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0700
- Transmission Control Module (TCM) Requested MIL Illumination
Circuit/System Description
This DTC indicates that an emission related transmission DTC has set in the transmission control module (TCM). The engine control module (ECM) turns ON the malfunction indicator lamp (MIL) when the TCM sends a message over the serial data circuit requesting MIL illumination.
Conditions for Running the DTC
* The ignition is ON.
* DTC P0700 runs continuously.
Conditions for Setting the DTC
Serial Data communication from the TCM indicates a fault exists with the transmission.
Action Taken When the DTC Sets
DTC P0700 is a Type A DTC.
Conditions for Clearing the MIL/DTC
DTC P0700 is a Type A DTC.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Diagnostic Trouble Code Descriptions)
Circuit/System Verification
1. DTC P0700 is an informational DTC. If there are any engine controls DTCs in the ECM or TCM, refer to Diagnostic Trouble Code (DTC) List - Vehicle (Diagnostic Trouble Code Descriptions).
2. Engine running, observe the DTC information with a scan tool. DTC P0700 should not set.
3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.