Rear Seat Back Cushion Replacement

Rear Seat Back Cushion Replacement

Removal Procedure

Warning: Refer to SIR Warning (SIR Warning).

1. Remove the upper trunk trim. Refer to Rear Compartment Trim Panel Replacement (Service and Repair).




2. Remove the upper retaining nuts (1) from the rear seat back.
3. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement (Rear Seat Cushion Replacement).




4. Remove the center seat belt (2) and shoulder belt buckle nut (1), if equipped.
5. Place the center shoulder belt on the rear shelf panel.




6. Remove the lower seat back retaining nuts (1).




7. Pull out on the top of the rear seat back.
8. Position the rear shoulder belts to clear the rear seat back during removal.
9. Remove the rear seat back.

Installation Procedure




1. Install the rear seat back into the car.





Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the upper retaining nuts (1) to the seat back studs (2) and tighten to 9 Nm (80 lb in).
3. Install the upper trunk trim. Refer to Rear Compartment Trim Panel Replacement (Service and Repair).




4. Install the rear seat back retaining nuts (1) and tighten to 30 Nm (22 lb ft).





Note:
* Ensure that the bolt threads and bolt holes are free of any sealer patch material.
* Ensure the seat belt buckles are properly positioned.

5. Install the center seat belt (2) and shoulder belt buckle anchor nut (1) and tighten to 30 Nm (22 lb ft).
6. Install the rear seat cushion. Refer to Rear Seat Cushion Replacement (Rear Seat Cushion Replacement).