Cylinder Head Assembly
CYLINDER HEADLeft:
Right:
Cylinder Head Bolt M11
First Pass - In Sequence 30 Nm (22 lb ft)
Second Pass - In Sequence 60 degrees
Third Pass - In Sequence 60 degrees
Final Pass - In Sequence 60 degrees, total 180 degrees
Cylinder Head Bolt M6 12 Nm (106 lb in)
CYLINDER HEAD BOLT RE-USABILITY
NOTE: DO NOT reuse the old M11 cylinder head bolts.
SURFACE VARIATION
Cylinder Head Deck Surface Flatness 0.100 mm (0.0039 in)
Surface Flatness - Block Deck 0.050 mm (0.0020 in)
Surface Flatness - Exhaust Manifold Deck 0.220 mm (0.0087 in)
Surface Flatness - Intake Manifold Deck 0.220 mm (0.0087 in)
Intake Manifold
Surface Flatness 0.500 mm (0.0200 in)
INTAKE MANIFOLD
Intake Manifold Mounting Bolt 10 Nm (89 lb in)
CAMSHAFT BEARING CAP
Exhaust Camshaft - Left Side:
Intake Camshaft - Left Side:
Exhaust Camshaft - Right Side:
Intake Camshaft - Right Side:
Camshaft Bearing Cap Bolt
First Pass 5 Nm (44 lb in).
Final Pass an additional 30 degrees*
*Using the J 45059 - Angle Meter.
EXHAUST MANIFOLD
Right:
Left:
Exhaust Manifold Bolt and Nut 25 Nm (18 lb ft)
Exhaust Manifold Stud 6 Nm (53 lb in)