Instrument Panel Trim Panel Replacement - Left Side
Instrument Panel Trim Panel Replacement - Left Side
Removal Procedure
1. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).
2. Remove the retaining screw at the bottom of the trim panel.
3. Pull the left trim panel outward to disengage the retaining clips from the I/P carrier.
4. Disconnect the electrical connectors.
5. Remove the electrical switches.
Installation Procedure
1. Install the electrical switches to the I/P trim panel.
2. Connect the electrical connections to the I/P trim panel.
3. Push on the left trim panel to engage the retaining clips to the I/P carrier.
Caution: Refer to Fastener Caution (Fastener Caution).
4. Install the retaining screw at the bottom of the trim panel and tighten to 1.9 Nm (17 lb in).
5. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).