Power Mirror Tilt Inoperative in Reverse

Power Mirror Tilt Inoperative in Reverse

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

Circuit/System Description

The driver door module (DDM) and passenger door module (PDM) each provide motor control output functions for their respective mirrors. These output controls allow each door module to command their respective power mirrors in horizontal and vertical positions. When the door modules detect an active mirror command they will command the respective mirror motor in the appropriate direction. Each door module controls their respective mirror motors by applying a ground or voltage to the control circuit, depending on the desired mirror position.

Reference Information
Schematic Reference

Outside Rearview Mirror Schematics (Outside Rearview Mirror Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Outside Mirror Description and Operation (Outside Mirror Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

1. Ignition ON, verify the park assist option is activated in the driver information center (DIC).
2. Select the driver outside mirror, shift the vehicle in REVERSE, verify that the driver outside mirror tilts.

• If the mirror doesn't tilt, replace the DDM.

3. Select the passenger outside mirror, shift the vehicle in REVERSE, verify that the passenger outside mirror tilts.

• If the mirror doesn't tilt, replace the PDM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for DDM and PDM replacement, setup, and programming