Front Floor Panel Carpet Replacement

Front Floor Panel Carpet Replacement

Removal Procedure

1. Remove the seat. Refer to Driver or Passenger Seat Replacement (Driver or Passenger Seat Replacement).
2. Remove the door manual release actuator. Refer to Door Inside Manual Release Actuator Replacement (Service and Repair).
3. Remove the door sill trim plate. Refer to Carpet Retainer Replacement (Service and Repair).




4. Remove the accelerator pedal stop bracket.




5. Remove the driver foot rest.




6. Pull the carpet from under the I/P and accessory trim plate. The graphic shows the driver side; the passenger side is similar.
7. Pull the carpet from under both sides of the center console.
8. Pull the carpet down and out from the bottom of the rear window trim panel.
9. Pull the seat electrical connector down through the carpet
10. Remove the carpet.

Installation Procedure





Warning

In order to avoid personal injury or vehicle damage when you repair or replace the carpet, use the same thickness and material size as the original installation. Always return the carpet to the original location.

1. Position the carpet over the floor.
2. Pull the electrical connector up through the carpet
3. Tuck the carpet under the accelerator pedal.
4. Tuck the carpet under the bottom of the rear window trim panel.
5. Tuck the carpet under both sides of the console.





Caution: Refer to Fastener Caution (Fastener Caution).

6. Install the accelerator pedal stop. Tighten the stop nuts to 10 Nm (89 lb in).




7. Install the driver side foot rest. Tighten the foot rest nuts to 10 Nm (89 lb in).




8. Tuck the carpet under the I/P and accessory trim plate.
9. Install the side sill trim plate. Refer to Carpet Retainer Replacement (Service and Repair).
10. Install the door manual release actuator. Refer to Door Inside Manual Release Actuator Replacement (Service and Repair).
11. Install the seat. Refer to Driver or Passenger Seat Replacement (Driver or Passenger Seat Replacement).