Inside Rearview Mirror Replacement

Inside Rearview Mirror Replacement

Removal Procedure




1. Remove the outside moisture sensor. Refer to Windshield Outside Moisture Sensor Replacement (Service and Repair).
Remove the outside moisture sensor cover, pulling rearward at the base of the cover, no tools are required.




2. Remove the electrical connector (1) from the back of the inside rearview mirror (2).





Caution: Do NOT pull rearward on the rearview mirror while installing or removing the mirror. Damage to the support or to the windshield may occur.

3. Remove the inside rearview mirror by pushing inward and turning firmly clockwise.
An audible click is heard when the inside rearview mirror is releasing from the support.
4. Remove the inside rearview mirror from the support.

Installation Procedure




1. Perform the following steps to install the inside rearview mirror:

Caution: Do NOT pull rearward on the rearview mirror while installing or removing the mirror. Damage to the support or to the windshield may occur.

2. Line up the back of the rearview mirror with the support on the windshield.
3. Push firmly and turn counter-clockwise until an audible click is heard.




4. Install the electrical connector (1) to the back of the inside rearview mirror (2).




5. Remove the outside moisture sensor cover. Refer to Windshield Outside Moisture Sensor Replacement (Service and Repair).
Install the outside moisture sensor wiring harness cover, by snapping in it place, no tools are required
6. Inspect the mirror for proper operation.