Keyless Entry Module: Service and Repair

Remote Control Door Lock Receiver Replacement

Removal Procedure

1. Turn the ignition to OFF.
2. Remove the instrument panel (I/P) trim pad. Refer to Instrument Panel Trim Pad Replacement (Service and Repair).




3. Remove the retaining screws from the remote control door lock receiver.
4. Remove the receiver from the I/P carrier in order to access the wire harness connection.
5. Disconnect the wire harness connector from the door lock receiver.
6. Remove the door lock receiver.

Installation Procedure




1. Connect the receiver connector and route the wire harness through the I/P carrier.
2. Line up the receiver with the hole on the retainer.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the retaining screws to the remote control door lock receiver and tighten to 2.5 Nm (22 lb in).
4. Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement (Service and Repair).
5. Perform the RCDLR programming and setup procedure. Refer to Control Module References (Programming and Relearning) for programming and setup information.